Automatic Door


We can complete PPM Services to a frequency that you require, either by recommendation or by legal requirement.

When we maintain an Automatic Entrance we:

  • Isolate Mains and remove all necessary covers
  • Check automatic door operator is accessible
  • Check the condition of the automatic doors
  • Check what type of automatic door swing/folding/telescopic/low energy/other
  • Check whether floor guide tracks are worn, check carriage wheels operate smoothly
  • Check pivots and door thresholds
  • Check safety barriers (if applicable)
  • Check alignment of doors
  • Check Opening width, Opening, hold open and closing  timing
  • Check Activation distances for inner/outer operations
  • Check all safety sensors including threshold safety (if applicable), slider rear edge safety sensors (if applicable) and photocells (if applicable) are working correctly
  • Swing door mounted hinges (if applicable)
  • Ensure no tripping hazards or finger trap hazards
  • Sliding Doors Leading to Jamb (if applicable)
  • Rear Stile to Mullion (if applicable)
  • Break outs (if applicable) , Break force (if applicable)
  • Static entrapment force
  • Fail safe, box test  ensure backup batteries work (if applicable)
  • Correct signage
  • Floor fixings, hinges
  • Glass panels are secure and in position
  • Check all consumables within operator Limit switches, motor and other consumable parts
  • Ensure no loose wiring
  • Check Locking (if applicable)
  • Carry out a thorough operation check or inspection to ensure resistance levels are acceptable and no binding or stiffness taking place and the door is operating correctly
  • Inspect mechanical aspects of the door and apply grease and lubricants as required
  • Reassemble door and replace all covers
  • Reinstate power and carry out fully functional test procedure
  • Leave site tidy and to clients satisfaction